Inspection And Maintenance Of Single-axle Traction Seat Of Tractor

1. During maintenance, check all components of the traction base, especially the wear of the traction pin, traction pin plate, semi-transverse shaft and other parts, and lubricate these parts; tighten the support base bolts and replace them if necessary; adjust The matching gap between the lock hook and the traction pin is adjusted by adjusting the screw rod. After adjustment, tighten it with the nut.
2. When disassembling the traction seat for inspection, pay attention to check whether there are cracks or serious wear on the traction seat itself. If there are cracks or severe wear and the traction seat is deformed or too thin, replace it with a new one; check the keyhole and use a traction pin for matching detection. , if the wear exceeds the limit and causes a large fitting gap, it can be repaired by overlay welding and processing to the required size, or the lock hook, lock block and wear-resistant ring can be replaced for repair; check the fitting gap between the support and the body, if the fitting is loose, then Replace the rubber elastic bushing; check the locking mechanism. Unhooking and hooking up should be smooth and crisp. The safety device should be stable and reliable. If there is any abnormality, check the lock hook tension spring and the numbered handle tension spring. Check the safety mechanism. If the spring elasticity is weakened, you should Replace with new parts.